![](https://imgs.michaels.com/MAM/assets/1/5E3C12034D34434F8A9BAAFDDF0F8E1B/img/7341D45F90AF4A81BE81B5D845A1FDEF/B_89705_1.gif?fit=inside|1024:1024)
fall pumpkin truck t-shirt
Step 1 |
First, click here for the link to the design. |
Step 2 |
Click ‘Make It’ in the upper right corner of your screen. |
Step 3 |
In your preview screen, check ‘Mirror’ for the gray, black, light green glitter and electric orange mats in the left panel to reverse your images; then click ‘Continue’ in the bottom right corner of your screen. |
Step 4 |
Choose the material for your first layer and place the heat transfer vinyl (HTV), shiny-side down, onto your cutting mat. Load the mat into your Cricut® machine, then press the blinking Cricut® icon to start cutting. |
Step 5 |
Once your machine is done cutting each layer, use scissors to cut your design from the HTV rolls. Next, use your weeder tool to remove all the excess material around and inside your design. You’ll be left with just the reversed design on the clear plastic carrier sheets, which are slightly sticky. |
Step 6 |
Follow the instructions as noted that are included with your heat press. |
Step 7 |
If your material is the warm peel type, you may go ahead and peel off the carrier sheet. If your material is a cool peel type, let it cool completely before removing the carrier sheet. |
Step 8 |
Repeat Steps 6-7 for each layer. Share your project photos with #MakeItWithMichaels |
- Computer
- 1 - SISER 9X12 HEAT PRESS (SKU 10629007)
- 1 - Siser Easypatterns® Heat Transfer Vinyl, Black & White Plaid (SKU 10644685)
Step 1 |
First, click here for the link to the design. |
Step 2 |
Click ‘Make It’ in the upper right corner of your screen. |
Step 3 |
In your preview screen, check ‘Mirror’ for the gray, black, light green glitter and electric orange mats in the left panel to reverse your images; then click ‘Continue’ in the bottom right corner of your screen. |
Step 4 |
Choose the material for your first layer and place the heat transfer vinyl (HTV), shiny-side down, onto your cutting mat. Load the mat into your Cricut® machine, then press the blinking Cricut® icon to start cutting. |
Step 5 |
Once your machine is done cutting each layer, use scissors to cut your design from the HTV rolls. Next, use your weeder tool to remove all the excess material around and inside your design. You’ll be left with just the reversed design on the clear plastic carrier sheets, which are slightly sticky. |
Step 6 |
Follow the instructions as noted that are included with your heat press. |
Step 7 |
If your material is the warm peel type, you may go ahead and peel off the carrier sheet. If your material is a cool peel type, let it cool completely before removing the carrier sheet. |
Step 8 |
Repeat Steps 6-7 for each layer. Share your project photos with #MakeItWithMichaels |