WELCOME Wood Porch Sign

First, in a well-ventilated area, spray paint your wood piece white. Let dry.

Next, click here for the design in Cricut® Design Space™.
TIP: If desired, adjust size to fit your wood piece and hide (or delete) the translated version you do not need.

Click ‘Make It’ in the upper right corner of your screen.

Now, click ‘Continue’ in the bottom right corner of your screen.

Attach your roll feeder to your machine and feed your first roll into the feeder and Cricut® 3 machine; then follow the prompts to cut out your design. Use the trimmer tool on your feeder to cut the section with your design away from the roll.
TIP: Repeat Step 5 for each mat/layer in your design.

Cut a piece of transfer tape that is just a bit larger than your design. Peel away the tape’s backer paper and place the tape, sticky-side down, over the vinyl. Burnish the vinyl so that it is completely stuck to the tape.
TIP: Cut transfer tape into sections. This will make attaching and removing it much easier.

Now, gently peel away the white backer paper and your design should now be stuck to the transfer tape.

Hold the transfer tape over your surface, to determine where and how you would like it placed; then press it onto your surface. Burnish the vinyl once more to make sure it is completely stuck to the surface and gently peel away the transfer tape, leaving the vinyl transferred onto your surface.

In a well-ventilated area, spray paint your wood piece grey. Remove the vinyl and let paint dry.

Repeat Steps 6-8 to add your vinyl letters.

Share your project photos with #MakeItWithMichaels