Time Required :
About 30 minutes
You're new to the skills necessary to complete this project, or maybe you've tried them just once or twice before.

twisted natural hemp bracelet

Thread metal beads as you make this trendy Twisted Natural Hemp Bracelet to wear this summer. You have plenty of hemp to make a matching necklace, anklet or more bracelets for your friends!
Step 1

First, cut a 72" [182.88 cm] piece and a 24" [60.96 cm] piece from 40 lb. hemp cord.

Step 2

At about 5" [12.7 cm] from one end, tie a double overhand knot.

Step 3

Tape the hemp cord to your working space, above the knot. This will be the base of your bracelet.

Step 4

Tie the 72" [182.88 cm] hemp cord around the base cord just below the knot. Make sure the strands on either side of the tie are even.

Step 5

Slide a bead onto the base and push it up to the tie.
TIP: Wrap a piece of tape around the end of the base cord and cut it to an angled point; then use it as a needle to help thread the bead onto your cord.

Step 6

Start your first square knot around the bead. To do this, take the right cord and fold it across the front of the base cord below the bead, horizontally, making the shape of a backward number “4”.

Step 7

Now, take the left cord and place it over the right cord, bend it back under the right cord and across back of the base cord then up through the opening of the backward “4”. Grab the ends of both cords and pull tight against the metal bead.

Step 8

For the next 11 knots, repeat Steps 6-7 without a bead.
TIP: Work each knot the same (from right to left) for this bracelet to create the twist.

Step 9

Slide on a bead and repeat Steps 6-8. Continue this pattern for 6½" [16.51 cm] of knots, or until you reach the desired length.

Step 10

Tie a double overhand knot with the base cord around the two outside working cords below the last bead.

Step 11

Trim the ends as close to the knot as you can and add a generous amount of glue. Let dry.

Step 12

Trim the excess base cord about 5" [12.7 cm] from the double overhand knot.

Step 13

To tie the sliding knot, overlap the ends of the cords about 2"-3" [5.08 cm - 7.62 cm]. Tie a knot with the end pointing towards the left, over the lacing. Repeat on the left side.
TIP: You can do simply tie a knot. Determine desired length of the necklace or bracelet, tie a knot and cut the excess.

Step 14
Tie a knot on each end of the excess cords so the cords do not slip through the sliding knot.

Share your project photos with #MakeItWithMichaels

Product Actions

Product Actions



  • You’ll Need: 1
    Item # 10146033 
    Add to cart options
  • You’ll Need: 1
    Item # 10332390 
    Add to cart options
  • You’ll Need: 1
    Item # 10436550 
    Add to cart options

Product Actions



  • You’ll Need: 1
    Item # 10454201 
    Add to cart options

Product Actions

You’ll Also Need
  • Ruler
  • Household Tape – Clear
+ View More