Panel (Make 2)
Row 1 Insert hook into first ch from hook, Yo and pull through. Leave loop on hook. Insert into next ch, yo and pull through. Repeat to the end. You should have 30 loops on your hook. Yo and pull through one loop. *Yo and pull through two loops*. Repeat from * to * across until one loop remains on the hook.
Row 2 Insert hook into the vertical bar, yo and pull through. Repeat across the row. You will have 19 loops on your hook. When you get to the end of the row, yo and pull through one loop. *Yo and pull through two loops*. Repeat from * to * across until one loop remains on the hook.
Row 3 - 27 Repeat Row 2.
Sl st the two panels together, back to back, on three sides. Leave one side open.
TIP: Use st markers to help hold the panels together when crocheting.
If desired, sc across the top of the back panel of the open side.
Ch 11. Leave a 6" [15.2 cm] tail to start.
Row 1 In 4th st from hook, dc 6 in same st. Skip one chain and dc 6 in next st. Repeat to end.
TIP: You should have 7 clusters of dcs.
Row 2 Ch 4. Turn your work and dc in the next 5 sts in first cluster. Ch 4. *In first st of next cluster, sl st, then ch 4. Dc in the next 5 sts in cluster.* Repeat from * to* for 5 clusters.
For the last 2 clusters, ch 2, sl st, then ch 2. Dc in the next 5 sts in cluster. At the end, ch 4 and sl st to base of last dc.
Trim yarn from skein and leave about a 6" [15.2 cm] tail.
Arrange your work into a 3D flower. Thread the tail from the last cluster through work to the bottom and tie a knot with the starting tail.
Thread tails through two sts on the front of your phone holder where desired and tie a knot inside. Trim tails.