collier ombré neutre simplement charmant

Cut an eight-link section from your chain spool.

Attach one end of the chain section to a hammered metal disc with a jump ring.
TIP: To open and close a jump ring, simply grasp the jump ring on both sides with chain nose pliers and twist the ring open, from side-to-side. Never pull the jump ring which can cause distortion.

Now, attach a rhinestone charm to each link of the chain section in an ombré fashion, as shown, or in order as desired.

Add a small 4mm jump ring to the top of the hammered metal disc.

Cut two 1" [2.54 cm] of chain.

Open another 4mm jump ring, add one end of each 1" [2.54 cm] chain piece, then slide onto the jump ring at the top of the disc. Close the jump ring.

Make two bead links from bicone crystal beads.
TIP: Slide three bicone beads onto an eye pin. Bend the wire of the eye pin in a 90° angle just above the bead. Grasp the eye pin wire, about 3/8"-½" [0.3 cm-1.3 cm] from the bend, between the jaws of your round nose pliers. Rotate the pliers toward you, keeping a firm grip on the wire, until a small loop is formed. Trim excess wire.

Attach one bicone bead link to the end opposite the disc of each 1" [2.54 cm] chain piece. To do this, carefully open a loop on the bead link, slide onto the last link of the chain and close the loop.

Cut two additional chain pieces to desired length for your necklace. Attach one end to the top of each bead link.

Finally, on one side add a jump ring and add a jump ring with a clasp on the other side.

Share your project photos with #MakeItWithMichaels