crystal radiance leopard fringe leather earrings

First, click here for the design in Cricut® Design Space™.

Click 'Make It' in the upper right of your screen. Click ‘Continue' in the lower right of the next screen.

Select your leather type; then place your material onto your cutting mat. Place masking tape around the perimeter of your leather on the mat for an extra secure hold.
TIP: Attach transfer tape to the back before you place on your cutting mat. This will save your mat from leather lint sticking and reducing the lifespan of your mat.

Load the mat into your Cricut® machine, change the housing in clamp B to the deep blade; then follow the prompts in Design Space®.

Remove the leather and pieces from the mat.

Repeat Step 3-5 for your balsa wood but this time, switch to your knife blade.
TIP: If needed, use an emery board to smooth the sides of your wood shape.

Attach crystals, evenly spaced, along the round edge of the bottom of your wood shapes. Let dry.

Open a large jump ring, add a wood shape then a leather shape and close the jump ring.

Add a fishhook earring with a small jump ring.

Repeat Steps 8-9 for a second earring.

Share your project photos with #MakeItWithMichaels