Print Project
seed bead storage container
Step 1 |
Wipe the area you want your design on your storage container with rubbing alcohol. |
Step 2 |
In Cricut® Design Space™, design your labels with desired font. Size as needed. |
Step 3 |
Now, click ‘Make It’ in the upper right corner, and then click ‘Continue’ in the lower right corner of your screen. |
Step 4 |
Place a sheet of vinyl, grid-side down, onto your cutting mat and load it into your Cricut® machine. Select ‘Vinyl’ as your material and follow the prompts to cut out your design. Once the machine has finished cutting, carefully peel the vinyl away from your mat. |
Step 5 |
Use scissors to cut away the vinyl around your design. Next, use your weeder tool to peel away the remaining negative around, and within, your design. When you are done, only the design itself should be left on the backer paper. |
Step 6 |
Cut a piece of transfer tape that is just a bit larger than the design. Peel away the tape’s backer paper and place the tape, sticky-side down, over the bottom layer of your design. Burnish the vinyl so that it is completely stuck to the tape. |
Step 7 |
Now, gently peel the white backer paper from the cut-out design, which now should be stuck to the transfer tape. |
Step 8 |
Hold the transfer tape with the design over your surface to determine where you would like it placed. Press it onto your surface. Burnish the vinyl once more to make sure it is completely stuck to the surface and gently peel away the transfer tape, leaving the vinyl transferred to your surface. |





- Computer
- Seed Bead Jars
- Rubbing Alcohol
- Paper Towel
Step 1 |
Wipe the area you want your design on your storage container with rubbing alcohol. |
Step 2 |
In Cricut® Design Space™, design your labels with desired font. Size as needed. |
Step 3 |
Now, click ‘Make It’ in the upper right corner, and then click ‘Continue’ in the lower right corner of your screen. |
Step 4 |
Place a sheet of vinyl, grid-side down, onto your cutting mat and load it into your Cricut® machine. Select ‘Vinyl’ as your material and follow the prompts to cut out your design. Once the machine has finished cutting, carefully peel the vinyl away from your mat. |
Step 5 |
Use scissors to cut away the vinyl around your design. Next, use your weeder tool to peel away the remaining negative around, and within, your design. When you are done, only the design itself should be left on the backer paper. |
Step 6 |
Cut a piece of transfer tape that is just a bit larger than the design. Peel away the tape’s backer paper and place the tape, sticky-side down, over the bottom layer of your design. Burnish the vinyl so that it is completely stuck to the tape. |
Step 7 |
Now, gently peel the white backer paper from the cut-out design, which now should be stuck to the transfer tape. |
Step 8 |
Hold the transfer tape with the design over your surface to determine where you would like it placed. Press it onto your surface. Burnish the vinyl once more to make sure it is completely stuck to the surface and gently peel away the transfer tape, leaving the vinyl transferred to your surface. |