Assiette décorative personnalisée pour la saison des Fêtes

First, click here for the design in Cricut® Design Space™. Use the provided name as a guide and replace with your family name or design your own to personalize the charger and wood slice.

Now, click ‘Make It’ in the upper right corner, and then click ‘Continue’ in the lower right corner of your screen.

Place the first layer of vinyl, grid-side down, onto your cutting mat and load it into your Cricut® machine. Select ‘Vinyl’ as your material and follow the prompts to cut out your design. Once the machine has finished cutting, gently peel the vinyl away from your mat. Repeat for your second vinyl layer.

Use scissors to cut away the vinyl around your design. Next, use your weeder tool to peel away the remaining negative space surrounding the initial and name. When you’re done, only the design itself should be left on the backer paper.

Cut a piece of transfer tape that’s just a bit larger than the design. Peel away the tape’s backer paper and place the tape, sticky-side down, over this part of the design. Burnish the vinyl so that it’s completely stuck to the tape.

Now, gently peel the white backer paper from the cut-out design, which now should be stuck to the transfer tape.

Hold the transfer tape with the design over your surface to determine where you’d like it placed. Make sure it is centered and straight; then press it onto your surface. Burnish the vinyl once more to make sure it’s completely stuck to the surface and gently peel away the transfer tape, leaving the vinyl transferred to your surface.

After you have personalized your chargers and wood slices for your dinner table. Lace a ribbon through the wood slice hole and tie it around a napkin.

Set your table using a matching napkin and a table runner.
TIP: Do not forget to clear plates so you can see the personalized charger!

Share your project photos with #MakeItWithMichaels