striped green plastic christmas ornament
Step 1 |
Run a strip of ¼" [0.64 cm] adhesive tape, vertically, from the top of one side, down the centre, around the bottom and back up to the top of the other side of your ornament. |
Step 2 |
Repeat Step 2 another time about halfway between the strips (from Step 1) which will form “+”. |
Step 3 |
Repeat Step 2, this time with 1/8" [0.32 cm] adhesive tape, between the current strips so you have eight even sections of ornament surface between adhesive strips. |
Step 4 |
Remove red covering from the last tape stripe placed on ornament, shake your glitter over the exposed tape until covered completely. |
Step 5 |
Repeat Step 4 for each strip until all have been glittered. |
Step 6 |
Make a small red bow with your ribbon and hot glue to the top of ornament(s). |
- Paper Plate
Step 1 |
Run a strip of ¼" [0.64 cm] adhesive tape, vertically, from the top of one side, down the centre, around the bottom and back up to the top of the other side of your ornament. |
Step 2 |
Repeat Step 2 another time about halfway between the strips (from Step 1) which will form “+”. |
Step 3 |
Repeat Step 2, this time with 1/8" [0.32 cm] adhesive tape, between the current strips so you have eight even sections of ornament surface between adhesive strips. |
Step 4 |
Remove red covering from the last tape stripe placed on ornament, shake your glitter over the exposed tape until covered completely. |
Step 5 |
Repeat Step 4 for each strip until all have been glittered. |
Step 6 |
Make a small red bow with your ribbon and hot glue to the top of ornament(s). |