quartz suede wrap bracelet

First, cut a piece of Gold wire to about 10" [25.4 cm]. Grasp the wire about 1½" [3.81 cm] from one end with round nose pliers.
TIP: Do this with a large part of the barrel of the pliers to make a larger loop.

With your free hand, grasp the top of the wire and bring it down, wrap it around the barrel, then, horizontally, across the wire below your pliers to a 90° angle.

Now, reach around and grab the horizontal wire and wrap it around the vertical wire a few times. Trim any excess wire.

Add a dab of glue to the hole on one side of a white quartz nugget. Slide the straight side of the wire in the hole until the loop you made is flush against the nugget.

Make another loop on the other side. Grasp the wire about 1" above the nugget and repeat Steps 2-3. Trim the wire and add a dab of glue around the hole to secure the wire. Set aside to dry.

Cut two 24" [60.96 cm] lengths of suede lace. Set one aside.

Fold one piece in half and thread one end through a loop on the side of the nugget until the loop is tucked inside the fold. Tie an overhand knot in the suede against the loop.
TIP: You should have two strands of lace hanging below the knot.

Tie another overhand knot in both suede strands about 4" from the end.

Go down about 1" [2.54 cm] and tie another overhand knot.

Thread a Gold bead onto each end and tie a knot. Trim ends, if needed.
TIP: Wrap a piece of tape around the end of the suede and cut the tape at an angle to help thread on beads.

Repeat Step 7 on the other side of the nugget.