lavender pearl earrings

Place a small jump ring against an ear hoop on the inside, at the top. Wrap a small piece of wire around both the jump ring and ear hoop on both sides to hold them together; then trim excess wire.
TIP: Use image as a guide.

Add a long length of thread to a beading needle.
TIP: Run your thread through the Magic Thread® to prevent ends from fraying or tangling.

Tie the thread end, opposite the needle, to the ear hoop and add a pearl to the thread.

Now, wrap the thread around the jump ring on the inside and back through the pearl.

Wrap the thread around the outside of the ear hoop and add two pearls. Repeat Step 5.

Continue adding pearls and weaving around the jump ring on the inside and the ear hoop on the outside until you get to the other side.
TIP: After each wrap, add one to four pearls, as desired, between the jump ring and ear hoop. Again, use the image as a guide.

Tie the end off and weave through a few pearls and trim thread.

Add the needle to the beginning excess thread and weave through a few pearls and trim thread.

Add a dab of glue to the knots on both sides.

Repeat Steps 1-9 for a second earring.

Share your project photos with #MakeItWithMichaels